Indoor Unit

• Install unit in the most desirable location for air circulation.
• There should not be any heating appliances adjacent to the unit.
• Ensure the space from the ceiling meets the manufacturers requirements.
• Install unit to allow proper drainage.

Pipework

• All pipe joints to be silver brazed or flare connections as applicable.
• All flares to be correct - pipe cleaned and reamed before flaring. Refrigeration oil or Vaseline to be used before tightening.
• Never leave pipework open for long periods of time.

Electrical

• All wiring to be as required to conform to current S.A.A. wiring rules.
• All unit connections to be bushed or terminated using knockouts provided.
• Wiring between indoor and outdoor units to run with pipework were possible.

Condenser

• Always position condenser on a level concrete slab/plinth or brackets as required.
• Fit vibration rubber under the condenser feet.
• Allow manufacturers clearances for service.
• Keep pipe and electrical connections from service duct to condenser at a minimum length.